Vimar Elvox SW230.T Anschluss- Und Bedienungsanleitung Seite 33

SW230.T / SW230.T.120
10.4. COMPLETE DOUBLE LEAF learning procedure WITHOUT deceleration.
1. Begin the procedure with the gate closed.
2. Adjust trimmer TR3 SL to the maximum setting (complete clockwise rotation), thereby excluding deceleration.
3. Press push button P1 and hold it down. LED DL7 starts to flash (1
4. Do not release push button P1 until it flashes faster (2
5. Release push button P1.
6. Follow the programming phases shown in the figure.
7. Programming ends when LED DL7 stops flashing.
CAUTION: After resetting or powering the board, the travel time of the first closing manoeuvre increases by approximately 5 seconds to allow the
completion of motion in any case.
1 START
st
2 START
nd
3 START
rd
4 START
th
5 START
th
flashing frequency).
st
flashing frequency).
nd
The first START begins the
learning process by moving
MOTOR 1 in opening
(Caution! start with the
gate closed)
The second START sets
the MOTOR 1 travel end
and should be pressed
when leaf 1 reaches the
stop
The third START sets the
MOTOR 2 travel end and
should be pressed when
leaf 2 reaches the stop
The fourth START sets the
MOTOR 2 travel end and
should be pressed when
leaf 2 reaches the stop
The fifth START sets the
MOTOR 1 travel end and
should be pressed when
leaf 1 reaches the stop
EN
6 START
th
M2 LEAF DELAY DURING
7 START
th
OPENING
8 START
th
M1 LEAF DELAY DURING
9 START
th
CLOSING
The sixth START starts
the leaf delay learning
by moving MOTOR 1 in
opening
The seventh START starts
MOTOR 2 after the desired
leaf opening delay
The eighth START starts
MOTOR 2 to learn the leaf
closing delay
The ninth START starts
MOTOR 1 after the desired
leaf closing delay
To complete programming,
wait for the gate to be
completely closed and LED
DL7 to be off
33