Vimar Elvox SW230.T Anschluss- Und Bedienungsanleitung Seite 31

SW230.T / SW230.T.120
10.2. COMPLETE DOUBLE LEAF learning procedure WITH deceleration.
1. Begin the procedure with the gate closed.
2. Press push button P1 and hold it down. LED DL7 starts to flash (1
3. Do not release push button P1 until it flashes faster (2
4. Release push button P1.
5. Follow the programming phases shown in the figure.
6. Programming ends when LED DL7 stops flashing.
CAUTION: After resetting or powering the board, the travel time of the first closing manoeuvre increases by approximately 5 seconds to allow the
completion of motion in any case.
1 START
st
DECEL.ZONE OP. M1
2 START
nd
3 START
rd
DECEL.ZONE OP. M2
4 START
th
5 START
th
6 START
st
DECEL.ZONE CL. M2
7 START
th
flashing frequency).
st
flashing frequency
nd
The first START begins the
learning process by moving
MOTOR 1 in opening
(Caution! start with the
gate closed)
The second START
sets the starting point
of MOTOR 1 opening
deceleration
The third START sets the
MOTOR 1 travel end and
should be pressed when
leaf 1 reaches the stop
The fourth START sets the
starting point of MOTOR 2
opening deceleration
The fifth START sets the
MOTOR 2 travel end and
should be pressed when
leaf 2 reaches the stop
The sixth START sets the
starting point of MOTOR 2
closing deceleration
The seventh START sets
the MOTOR 2 travel end
and should be pressed
when leaf 2 reaches the
stop
EN
DECEL.ZONE CL. M1
8 START
th
9 START
th
10 START
th
M2 LEAF DELAY DURING
11 START
th
OPENING
12 START
th
M1 LEAF DELAY DURING
13 START
th
CLOSING
The eighth START sets the
starting point of MOTOR 1
closing deceleration
The ninth START sets the
MOTOR 1 travel end and
should be pressed when
leaf 1 reaches the stop
The tenth START starts
the leaf delay learning
by moving MOTOR 1 in
opening
The eleventh START starts
MOTOR 2 after the desired
leaf opening delay
The twelfth START starts
MOTOR 2 to learn the leaf
closing delay
The thirteenth START
starts MOTOR 1 after the
desired leaf closing delay
To complete programming,
wait for the gate to be
completely closed and LED
DL7 to be off
31