Dell Latitude 7410 Einrichtung Und Technische Daten Seite 37

Table 38. System setup options—POST Behavior menu (continued)
POST Behavior
Table 39. System setup options—Virtualization menu
Virtualization
Intel Virtualization Technology
VT for Direct I/O
Table 40. System setup options—Maintenance menu
Maintenance
Asset Tag
Service Tag
BIOS Recovery from Hard Drive
BIOS Auto-Recovery
Start Data Wipe
Allow BIOS Downgrade
Table 41. System setup options—System Logs menu
System Logs
Power Event Log
BIOS Event Log
Thermal Event Log
NOTE: Errors deemed critical to the operation of the computer hardware
will always halt the computer.
Enables the computer to run a virtual machine monitor (VMM).
Default: ON.
Enables the computer to perform Virtualization Technology for Direct I/O (VT-d).
VT-d is an Intel method that provides virtualization for memory map I/O.
Default: ON.
Creates a system Asset Tag that can be used by an IT administrator to uniquely
identify a particular system. Once set in BIOS, the Asset Tag cannot be changed.
Displays the Service Tag of the computer.
Enables the computer to recover from a bad BIOS image, as long as the Boot Block
portion is intact and functioning.
Default: ON.
NOTE: BIOS recovery is designed to fix the main BIOS block and cannot
work if the Boot Block is damaged. In addition, this feature cannot work
in the event of EC corruption, ME corruption, or a hardware issue. The
recovery image must exist on an unencrypted partition on the drive.
Enables the computer to automatically recover the BIOS without user actions. This
feature requires BIOS Recovery from Hard Drive to be set to Enabled.
Default: OFF.
CAUTION: This Secure Wipe Operation will delete information in a way
that it cannot be reconstructed.
If enabled, the BIOS will queue up a data wipe cycle for storage devices that are
connected to the motherboard on the next reboot.
Default: OFF.
Controls flashing of the system firmware to previous revisions.
Default: ON.
Displays Power events.
Default: Keep.
Displays BIOS events.
Default: Keep.
Displays Thermal events.
Default: Keep.
System-Setup 37