Function - Gardena 19031 Betriebsanleitung

DANGER!
There is a risk of explosion if batteries are
not replaced in the proper manner.
See 6. STORAGE for information on how
to dispose of used batteries.
Do not use re­chargeable batteries.
In order to stop the Water Control from failing
because of a weak battery if you are away for
a long time, the battery must be replaced when
the battery display flashes yellow.
The batteries should not be removed while water­
ing (leads to continuous watering).

2. FUNCTION

Water Control:
Controls / Display:
Downloaded from www.Manualslib.com
The Water Control is controlled automatically with the GARDENA
smart App. Sprinklers, a sprinkler system or a drip head watering
system can be used for watering.
The Water Control carries out watering fully automatically according
to the set program and can therefore also be used during holidays.
Early in the morning or late in the evening, evaporation and therefore
water consumption is lowest.
1
(2)
1
(3)
2
3
4
(4)
manuals search engine
Setting up
WARNING!
The Water Control must not be used indoors.
v Only use the Water Control outdoors.
The Water Control may only be set up vertically
with the sleeve nut to the top to prevent water
penetrating into the battery compartment.
The minimum water output to ensure that the
Water Control functions correctly is 20 – 30 l/h.
For example, at least 10 ­ 15 x 2­litre Drip Heads
are required to control the Micro­Drip­System.
The max. temperature for the water flow is 40 °C.
v Only use clear fresh water.
The minimum operating pressure is 0.5 bar,
the maximum operating pressure is 12 bar.
Avoid tensile strain.
v Do not pull the hose connected to the
Water Computer.
LED Connection display / Signal:
Green flashing: While connecting
Green for 10 sec: Signal strength high
Yellow for 10 sec: Signal strength medium
Red for 10 sec: Signal strength low
LED Active watering:
Green for 10 sec.
LED Battery display:
Green for 20 sec: Capacity > 4 weeks
Yellow flashing: Capacity < 4 weeks
Red flashing: Capacity < 2 weeks
Red lightning: battery flat
If the LED lights red, the valve is no longer opened. A valve
opened by the program will also close again if the battery is flat.
The battery display is reset when the batteries are changed.
v Replace batteries (see 3. INSTALLATION "To insert batteries").
Man. Button:
For switching the water throughput on or off manually.
11