LASERLUCHS 5000 Kundenhandbuch Seite 24

Dimmer:
a. Dimmer mode
Switching on/off: Keep the operating button pressed for half
a second. Increasing (decreasing) output brightness: Turn
the operating button clockwise (anti-clockwise). Saving the
current brightness: When the equipment is switched off, the
current level of brightness is saved. The brightness of the
LED is synchronized with the brightness of the laser.
b. Pulse shift mode (possible only when the equipment is
switched on) Switching on: Press the operating button twice
in rapid succession within one second (double click). Increa-
sing (decreasing) frequency: Turn the operating button
clockwise (anti-clockwise). Switching off: Press the operating
button briefly. Return to the dimmer mode. The flashing of
the LED is synchronized with the laser.
c. SOS emergency signal
Keep the operating button pres-
sed down for seven seconds. The
flashing of the LED is synchronized
with the laser. To switch off, press
the operating button briefly.
If the button is kept pressed un-
interruptedly for more than 30 se-
conds, the dimmer switches off automa-
tically. Operation finishes without actuation after one hour.
Downloaded from www.Manualslib.com manuals search engine
1. Purpose:
The dimmer is intended for use with LASE
Illuminators and controls the intensity of the IR
Warning: Do not operate the dimmer in area
re is a risk of explosions. Do not operate the
der water. If water penetrates the housing, it
malfunctions or permanent damage. Have th
paired only by an authorized specialist works
LASERLUCHS® customer service. Do not mak
cations to the dimmer. Serious risks may resu
rect operation or use as well as from modific
to the dimmer. The sole power source must b
the type CR123A or lithium ion batteries of th
Note: Remove the battery if you are not us
dimmer over a longer period of time. Do not
or swallow the battery. Do not throw it onto a
2. Figure
–
24
Turn
+
Press