LASERLUCHS 5000 Kundenhandbuch Seite 22

Dimmer:
The LASERLUCHS® dimmer makes possible infinite adjust-
ment of the output brightness from 0 – 100%. This means
that the intensity of illumination can be adapted to the
user's requirements:
for example, so as to respond to different ambient levels of
brightness and to improve the contrast of the night vision
scope. The dimmer has been designed in such a way that
it can be operated comfortably in one hand. An intelligent
control system prevents the battery from discharging in the
event of its being operated unintentionally, e.g. during trans-
portation. The use of glass fibre optics and two-tone LED as
a visual display provides information on the operating con-
dition of the IR laser Illuminator and prevents unintentional
illumination of the user.
Preparation of the IR laser Illuminator
1) Unscrew the switch of the laser Illuminator and remove
the battery and spacer tube. The spacer tube is fastened
with silicone, but it may be released by being pulled out
using one finger. Any silicone residues must be comple-
tely removed before screwing down.
2) Place the battery type CR123A into the dimmer, by first
inserting the battery with the minus pole toward the
spring. Pull the battery with your fingers towards the
spring and install the second one.
3) Screw down into the Illuminator until there is closure
with the rubber seal.
Downloaded from www.Manualslib.com manuals search engine
22