Inside The Box; Installation - KEF Ci Serie Installationshandbuch

EN

Inside the box

Speaker driver x 1
Bezel x 1
Grille x 1

Installation

1. Cut the hole in the ceiling (158 x 158mm)
2. Insert the bezel by placing into the hole and tightening the clamps using a screwdriver. If using an electric screwdriver, ensure
torque is on the lowest setting (<10kgf). Do not overtighten.
3. Apply the supplied jointing tape, covering the flange of the bezel as shown without overlapping the tape. Insert the black
cover.
4. Plaster over the bezel, following the plaster manufacturer's instructions. Ensure the bezel is completely plastered over, and
that all the holes in the flange are filled.
5. Repeat plastering as required to achieve a level surface, allowing the plaster to dry between each application. The protective
cover can be used as a guide.
6. Sand plaster back and remove all plaster from the black cover until the cover is completely visible. It is recommended using
120/180 grit sanding paper on an orbital sander or a hand sanding block. Do not over sand as this may reveal the jointing
tape and weaken the joint
7. Carefully remove black cover. Touch up any areas where plaster has come away with the cover and allow to dry.
8. Reinsert the black cover. Paint the plastered area with the rest of the ceiling.
9. Fit the speaker cable to the speaker driver.
10. Tighten the retaining screws with a screwdriver (<10kgf). Take care not to overtighten, as this may cause damage.
11.. Insert magnetic grille.
Decoration (Paint the grille)
1. Remove the scrim cloth before painting the grille
2. Paint the grille and allow it to dry thoroughly
3. Reattach scrim cloth. No additional adhesive is required.
Black cover x 1
Jointing tape x 4
Installation manual x 1