Fcc Information To The User - T+A E-Series 1000 Betriebsanleitung

Approval and
conformity
with EC
directives
Disposing of
this product
FCC
Information to
the user
Downloaded from www.Manualslib.com
In its original condition the unit meets all currently valid European
regulations. It is approved for use as stipulated within the EC.
By attaching the CE symbol to the unit  declares its conformity with
the EC directives 2006/95/EC, 2004/108/EC and 2009/125/EC and the
national laws based on those directives.
The original, unaltered factory serial number must be present on the
outside of the unit and must be clearly legible! The serial number is a
constituent part of our conformity declaration and therefore of the
approval for operation of the device.
The serial numbers on the unit and in the original  documentation
supplied with it (in particular the inspection and guarantee certificates),
must not be removed or modified, and must correspond.
Infringing any of these conditions invalidates  conformity and
approval, and the unit may not be operated within the EC. Improper use
of the equipment makes the user liable to penalty under current EC and
national laws.
Any modifications or repairs to the unit, or any other intervention by a
workshop or other third party not authorised by , invalidates the
approval and operational permit for the equipment.
Only genuine  accessories may be connected to the unit, or such
auxiliary devices which are themselves approved and fulfil all currently
valid legal requirements.
When used in conjunction with auxiliary devices or as part of a system
this unit may only be used for the purposes stated in the section
'Approved usage'.

The only permissible method of disposing of this product is to take it to
your local collection centre for electrical waste.
(for use in the United States of America only)
Class B digital device – instructions:
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different form that to
which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
manuals search engine
23