Troubleshooting - T+A E-Series 1000 Betriebsanleitung

Many problems have a simple cause and a correspondingly simple solution. The following
section describes a few difficulties you may encounter, and the measures you need to take to
cure them. If you find it impossible to solve a problem with the help of these notes please
disconnect the unit from the mains and ask your authorized  specialist dealer for advice.
The Playback volume is
too low compared to other
sources.
The sound is too bright or
too dull.
The audio signal is
extremely low in volume
and noisy.
The audio signal is
extremely loud and the
sound is distorted.
Loud humming noise from
the loudspeakers.
Downloaded from www.Manualslib.com

Troubleshooting

Cause:
The input sensitivity is not correctly adjusted.
Remedy:
Change the input sensitivity on both channels to a lower value.
Cause:
The input capacitance is not correctly adjusted.
Remedy:
Change the input capacitance on both channels to match the
requirements of your cartridge.
Cause:
The cartridge is an MC (Moving Coil) system and the phono
preamp is a MM version.
Remedy:
Please use the correct phono preamp version suitable for your
pick-up system.
Cause:
The cartridge is an MM (Moving Magnet) system and the
phono preamp is a MC version.
Remedy:
Please use the correct phono preamp version suitable for your
pick-up system.
Cause 1:
Poor contact between the RCA or XLR plugs and sockets, or a
faulty cable.
Remedy:
Please check all connections and cables thoroughly.
Cause 2:
The turntable or a device connected to it is not earthed.
Remedy:
Connect a separate chassis earth wire from turntable to
R 1000 E.
manuals search engine
22