Setting The Input Resistance - T+A E-Series 1000 Betriebsanleitung

Setting the input
impedance
(Impedance)
Downloaded from www.Manualslib.com
Miniature switches „2" are used to set the desired input impedance for the
left (2L) and right (2R) channels.
The information you need for this will be included in the manufacturer's
specification for the pick-up system you intend to use.
Select the value which is closest to the manufacturer's stated figure. It is
essential to set the same value for both channels.
If you do not have access to the manufacturer's specification, a good
starting point for input impedance is 100 . This is the factory default
setting.
OFF
OFF
OFF
OFF
OFF
OFF
ON
ON
ON
manuals search engine
OFF OFF OFF
OFF OFF ON
OFF ON OFF
OFF ON ON
ON OFF OFF
ON ON OFF
OFF OFF OFF
ON OFF OFF
ON ON ON
21
Input impedance []
450  650 
...
200  449 
...
130  199 
...
85  129 
...
50  84 
...
30  49 
...
20  29 
...
16  19 
...
15 
<
Table 4