Adjustment Facilities On The Phono Module Mm; Setting The Input Sensitivity - T+A E-Series 1000 Betriebsanleitung

Adjustment facilities on the Phono module MM

Switch positions
Setting the input
sensitivity
(Gain)
Input sensitivity
Downloaded from www.Manualslib.com
1L
2L
Miniature switches „1" are used to set the desired input sensitivity for the
left (1L) and right (1R) channels as shown in Table 1.
The information you need for this will be included in the manufacturer's
specification for the pick-up system you intend to use. Select the value
which is closest to the manufacturer's stated figure. It is essential to set
the same value for both channels.
If you do not have access to the manufacturer's specification, a good
starting point for sensitivity is 3.5 mV. This is the factory default setting.
OFF OFF
OFF OFF
OFF OFF
OFF ON
ON OFF
manuals search engine
1R
2R
OFF OFF
ON
OFF
ON OFF
OFF OFF
OFF OFF
18
Input sensitivity [mV]
...
6,0 10,0
...
3,5 6,0
...
2,5 3,5
...
1,5 2,5
...
1,0 1,5
Table 1