Upright AB-46 Bi-Energy Betriebsanleitung Seite 6

DO NOT operate the machine if the platform
does not maintain level when elevated.
Note: Platform leveling can be performed only with
the boom stowed and should be done only to
calibrate the automatic leveling system.
1. Set the function speed control dial to the desired
setting. Rotate the dial clockwise to increase speed,
counterclockwise to decrease. If you are not sure
what speed to use, start out slow; the speed can be
varied while operating the function.
2. While depressing the foot switch, push the platform
level control switch forward to swing the platform
upward, rearward to swing the platform downward.
Release the switch to stop leveling.
1. Set the function speed control dial to the desired
setting. Rotate the dial clockwise to increase speed,
counterclockwise to decrease. If you are not sure
what speed to use, start out slow; the speed can be
varied while operating the function.
2. While depressing the foot switch, turn the turret
rotation control switch counterclockwise to rotate
left, clockwise to rotate right. Release the switch to
stop rotation. Observe the area around the boom
when rotating the turret to avoid any obstructions.
1. While depressing the foot switch, push the riser
control lever forward to elevate the riser, rearward to
lower the riser. Release the control lever to stop
elevating / lowering. The riser will function at a
constant speed, function speed control setting is not
necessary.
Downloaded from www.Manualslib.com
Leveling the Platform
Rotating the Turret
Elevating the Riser
manuals search engine
Elevating the Upper Boom
1. Set the function speed control dial to the desired
setting. Rotate the dial clockwise to increase speed,
counterclockwise to decrease. If you are not sure
what speed to use, start out slow; the speed can be
varied while operating the function.
2. While depressing the foot switch, push the upper boom
control lever forward to elevate the upper boom,
rearward to lower the upper boom. Release the control
lever to stop elevating / lowering.
Extending the Upper
Boom
1. While depressing the foot switch, push the boom
extension control lever rearward to extend the boom,
forward to retract the boom. Release the control
lever to stop extending / retracting. The boom
extension will function at a constant speed, function
speed control setting is not necessary.
Elevating the Jib
1. Set the function speed control dial to the desired
setting. Rotate the dial clockwise to increase speed,
counterclockwise to decrease. If you are not sure
what speed to use, start out slow; the speed can be
varied while operating the function.
2. While depressing the foot switch, push the jib control
lever forward to elevate the jib, rearward to lower the
jib. Release the control lever to stop elevating /
lowering.
Rotating the Platform
1. Set the function speed control dial to the desired
setting. Rotate the dial clockwise to increase speed,
counterclockwise to decrease. If you are not sure
what speed to use, start out slow; the speed can be
varied while operating the function.
2. While depressing the foot switch, turn the platform
rotation control switch counterclockwise to rotate
left, clockwise to rotate right. Release the switch to
stop rotation.
6