Safety Rules - Upright LX Serie Betriebsanleitung

NEVER operate the machine
within ten feet of power lines.
THIS MACHINE IS NOT
INSULATED.
NEVER operate the machine without first surveying the work area for surface hazards such as holes,
drop-offs, bumps and debris.
NEVER operate the machine if all guardrails are not properly in place and secured with all fasteners properly
torqued.
SECURE and lock gate after mounting platform.
KEEP all body parts clear of outriggers when extending or retracting.
NEVER use ladders or scaffolding on the platform.
NEVER attach overhanging loads or increase platform size.
LOOK up, down and around for overhead obstructions and electrical conductors.
DISTRIBUTE all loads evenly on the platform. See the back cover for maximum platform load.
NEVER use damaged equipment. (Contact UpRight for instructions. See toll-free phone number on back
cover.)
NEVER change operating or safety systems.
INSPECT the machine thoroughly for cracked welds, loose hardware, hydraulic leaks, damaged
control cable, loose wire connections and wheel bolts.
NEVER climb down elevating assembly with the platform elevated.
NEVER perform service on machine while platform is elevated without blocking elevating assembly.
NEVER recharge battery near sparks or open flame; batteries that are being charged emit highly
explosive hydrogen gas.
AFTER USE secure the work platform against unauthorized use by turning key switch off and removing
key.
NEVER replace any component or part with anything other than original UpRight replacement parts
without the manufacturer's consent.
Downloaded from www.Manualslib.com
English Language Section

SAFETY RULES

NEVER elevate the platform
or drive the machine while
elevated unless the machine is
on firm level surface.
manuals search engine
NEVER sit, stand or climb on
guardrail or midrail.
2