Ebode IPV38P2P Schnellstartanleitung Seite 8

Notes:
If you forget your username or password, press and hold the reset button on the

bottom of the camera using a pin for 5 seconds. This resets the camera to factory default.
If you want to access the camera over wireless or Internet, continue with the setup

by following the Wireless and Remote Access steps below.
4. Wireless Connection
WPS (Wi-Fi Protected Set-up), recommended to setup wireless connection.
1. Press and hold the WPS button for two seconds.
2. Press the WPS button on your wireless router within 60 seconds. The WPS button is
usually on the front or back of your router. If you are not sure about the WPS function of
your router, please refer to your router's User Manual.
3. The camera will automatically create a secure wireless connection to your router in
about 60 seconds. If you have connected the network cable, please disconnect it.
Note: Please set the security mode of your router to WPA-PSK/WPA2-PSK, or the WPS
settings may be failed.
If wireless router doesn't support WPS function, please setup by the following steps.
4. Choose "Settings" on top of the camera web page, then go to "Network - Wireless
Settings" section on the left side of the screen, then click "Scan".
25-8-2014 - 8 -
WPS Button
ebode IPV38P2P