Environmental Considerations - AEG KDK911423 Bedienungsanleitung

14 www.aeg.com
Alarm messages
8.2 Assistance Data
If it is not possible to find a solution to
the problem, contact the authorised
Assistance Centre.

9. ENVIRONMENTAL CONSIDERATIONS

Recycle materials that carry this
symbol
Dispose of the packaging in special
containers for recycling. Help protect
the environment and human health and
recycle waste deriving from electric and
electronic devices.
Downloaded from www.Manualslib.com
The vacuum The cover gasket is dirty or worn.
cycle is stopped
within a few
seconds and
the button
flashes.
Alarm
The button will The electrical board is faulty.
flash continuously.
The vacuum is not produced.
The button will
flash continuously.
The pump oil must be replaced. Contact the Technical Assistance
The and
buttons flash
continuously.
The packaging cycle is
The
terminated in advance
button flashes
because a wet product is being
continuously.
packaged.
.
manuals search engine
Possible cause
The information required for the
Assistance Centre is found on the data
plate on the left side of the appliance. Do
not remove the data plate.
Do not dispose of appliances that carry
this symbol
waste.
Return the product to your local recycling
facility or contact your municipal office.
Clean or replace the gasket of the
cover and check that it is closed
properly.
Solution
Contact the Technical Assistance
Service.
Clean or replace the cover gasket
(contact the Technical Assistance
Service to replace it).
Make sure the cover closes
correctly.
Press the button to reset the
alarm.
Service.
Press the button to reset the
alarm.
together with domestic