Environmental Considerations - AEG VS91404 Bedienungsanleitung

14 www.aeg.com
The vacuum
cycle is stopped
within a few
seconds and
the
flashes.
Alarm messages
The
flash continuously.
The
flash continuously.
The
buttons flash
continuously.
The
button flashes
continuously.
8.2 Assistance Data
If it is not possible to find a solution to
the problem, contact the authorised
Assistance Centre.

9. ENVIRONMENTAL CONSIDERATIONS

Recycle materials that carry this
symbol
Dispose of the packaging in special
containers for recycling. Help protect
the environment and human health and
recycle waste deriving from electric and
electronic devices.
The cover gasket is dirty or worn.
button
Alarm
button will The electrical board is faulty.
The vacuum is not produced.
button will
The pump oil must be replaced. Contact the Technical Assistance
and
The packaging cycle is
terminated in advance
because a wet product is being
packaged.
.
Possible cause
The information required for the
Assistance Centre is found on the data
plate on the left side of the appliance. Do
not remove the data plate.
Do not dispose of appliances that carry
this symbol
waste.
Return the product to your local recycling
facility or contact your municipal office.
Clean or replace the gasket of the
cover and check that it is closed
properly.
Solution
Contact the Technical Assistance
Service.
Clean or replace the cover gasket
(contact the Technical Assistance
Service to replace it).
Make sure the cover closes
correctly.
Press the button to reset the
alarm.
Service.
Press the button to reset the
alarm.
together with domestic