Victron energy Blue Smart IP67 12/7 Anleitung Seite 6

Installation and instructions for use
1. The battery charger must be installed in a well-ventilated area
close to the battery (but, due to possible corrosive gasses not
above the battery!)
2. Connect the ring terminals to the battery: the minus cable
(black) to the minus (–) pole of the battery, the plus cable (red) to
the plus (+) pole of the battery.
3. Plug the AC mains cable into the wall socket. The charge cycle
will now start.
Two LEDs for status indication
Yellow LED:bulk charge (blinking fast), absorption (blinking slow),
float (solid), storage (off)
Green LED: power on
Safety regulations and measures
1. Install the charger according to the stated instructions
2. Connections and safety features must be executed according
to the locally applicable regulations.
3. Warning: do not attempt to charge non-rechargeable batteries.
4. Warning: a BMS (Battery Management System) may be
required to charge a Li-ion battery.
5. This appliance is not intended for use by persons with reduced
physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person
responsible for their safety. Children should be supervised to
ensure that they do not play with the appliance.
6. The charger is designed for lead-acid and Li-ion batteries 14-
225Ah. Do not use for any other purpose.
4