Specification - Status OS300/150 Originalanleitung

5. SPECIFICATION

• Remove dust and machining residuals with a brush with soft bristles.
• Do not wet or spray water over the electrical tool - risk of internal infiltrations.
• Do not use any inflammables, detergents or solvents.
• The plastic parts can easily be damaged by chemical agents.
• Do not use compressed air for cleaning: Risk of material ejection!
• Pay particular attention to cleaning the switch, the motor ventilation slots, the holes on
the backing plate and the abrasive support driving rollers.
• Open the dust box cover (fig. 3) to empty the contents. Clean the inside with a small
brush and reassemble.
• Remove any traces of wood resin.
ABRASIVE SUPPORT REPLACEMENT
• Velcro type: Turn the machine over, rip the abrasive support off the backing plate,
clean, attach the new abrasive support, check that the sheet is taut and that the holes
correspond to the holes on the backing plate.
• Sheet type: Turn the machine over, open the tensioning device, extract the sheet,
clean, put on the new sheet, close the tensioning device, check that the sheet is taut
and that the holes correspond to the holes on the backing plate
• Belt type: Turn the machine over, open the tensioning lever, extract the belt, clean,
insert the new belt taking care to respect the rotation direction, checking the arrow
printed on the machine against that on the belt, close the tensioning lever, check that
the belt is taut and, if necessary, adjust the centring using the knob.
• For all: At the end, carry out a trial run.
ENVIRONMENT
• Do not dispose of electric tools, accessories and packaging together with
household waste material (only for EU countries)
- in observance of European Directive 2012/19/EC on waste of electric and electronic
equipment and its implementation in accordance with national law, electric tools that
have reached the end of their life must be collected separately and returned to an
environmentally compatible recycling facility
ACCESSORIES
Sander OS300/150, d ust box, manual, packing.
SPECIFICATION
Rating voltage
Rating power
No load speed
Weight
NOISE/VIBRATION
Measured in accordance with EN 60745:
- the sound pressure level of this tool is 77,5 dB(A) (standard deviation: 3 dB)
- the sound power level 88,5 dB(A) (standard deviation: 3 dB),
- the vibration 6,966 m/s² (hand-arm method; uncertainty K =1.5 m/s²)
EN
220-240V~ 50Hz
6000 - 12000 RPM
8
6. CE DECLARATION OF CONFORMITY
CE DECLARATION OF CONFORMITY
We STATUS ITALIA S.R.L. as the responsible manufacturer declare that the
following STATUS machine(s): Random orbit sander OS300/150 are of series produc-
tion and сonforms to the following European Directives: 2006/42/EC, 2014/30/EU.
And are manufactured in accordance with the following standards or standardised
documents: EN 62841-1:2015+AC:15, EN62841-2-4:2014,
EN 55014-1:2006+A1:2009/+A2:2011, EN 55014-2:2015,
EN 61000-3-2:2014, EN 61000-3-3:2013.
The technical documentation kept by the manufacturer: STATUS ITALIA S.R.L.,
via Aldo Moro, 14/A, 36060 - Pianezze (VI), ITALY
450 W
1,75 kg
Caron Giacinto
Director
STATUS ITALIA S.R.L.
9
EN