Weidmuller WAVE Serie Beipackinformation Seite 10

1. General instructions
Warning! The analogue signal isolators of the WAVE
stalled by qualified personnel. e sure not to connect the unit to
power supply before appropriate installation. Do not
select ranges during operation, because live parts are exposed
during this process.
Be sure to observe the national regulations for installation and
selection of cables.
Appropriate safety measures against electrostatic discharge
(ESD) should be taken during assembly and adjustment work on
the WAVE
2. Application
The analog signal isolator WAVE
galvanic isolation and conditioning of current signals. Input
signals and output signals are permanently calibrated and
cannot be conditioned.It is not necessary to adjust the
pre-settable measurement ranges.
8
OLP.
ANALOG
ANALOG
2 OLP is used for the
ANALOG
may only be in-