Waeco CA-45 Bedienungsanleitung Seite 24

_CA-45.book Seite 24 Montag, 3. Mai 2004 9:22 09
Operating the cooler
➤ Select a cable cross section for the cable between the battery and the
Cable length
Up to 2.5 m
2.5 m to 4.0 m
➤ Make sure that the thermostat control for 220 V – 240 V operation (2 2,
➤ Insert the plug of the connection cable into the 12 V socket
➤ To switch off the cooler, pull the plug out of the socket.
Connecting to a gas source
➤ Position the gas bottle vertically at a distance of at least 1 metre away
➤ Check if the valve on the gas bottle is closed.
➤ Connect the hose line to the head of the valve on the gas bottle and the
➤ Make sure that the hose line
➤ Open the valve on the gas bottle.
24
Downloaded from www.Manualslib.com
socket of the 12 V voltage supply in accordance with the following table:
page 3) is in the "0" position.
(e.g. cigarette lighter).
The polarity cannot be reversed.
Only use propane or butane gas bottles with an approved
pressure reduction valve and suitable top part.
Compare the pressure information on the type plate with the
pressure information on the propane or butane gas cylinder.
The device is fitted with a pilot light. The gas supply is interrupted
when the flame goes out.
from the burner (on the back of the cooler).
Only use approved hose lines (DIN 4815 part 2) with a maximum
length of 1.5 m.
cooler (3 1, page 4).
Use an open-ended spanner with the appropriate width for this.
– Is not crushed or kinked
– Is a safe distance from the burner.
manuals search engine
Cable cross section
2.5 mm²
4.0 mm²
CA-45, CAB-45