Herunterladen Inhalt Inhalt Diese Seite drucken

Operation; Cleaning Of The Machine - ratiotec rapidcount S 575 Bedienungsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
Warnings
1.
Before switching on the machine, make sure that no foreign objects interfere with the operation of the
machine.
2. Do not place the machine in the immediate vicinity of water or other liquids.
3. To reduce the risk of electric shock, do not disassemble the machine yourself.
4. Use the mains cable supplied.
5.
Do not use the machine in an environment with high temperature or high humidity.

Operation

Connect the mains cable supplied to the machine power connector and a power source. Then press the ON | OFF
switch. After switching on the rapidcount S 575, the machine carries out a self-test. After a successful test, the
device is ready for use.
Initial commissioning: After switching on the device via the ON | OFF switch, pressing and holding the START
button will take you to the date & time settings. The START button should be pressed until a beep sounds and
the year in the top left corner of the display is grayed out. The grayed out indication can be changed by pressing
the MIX or CNT button. Press the START button again to go to the next entry. To save all the settings, press the
START button again for several seconds.
Fan the banknotes slightly and place the banknote stack to be counted centred and roughly sorted according to
size into the banknote feeder. When Autostart is activated, the banknote counting machine automatically starts
the counting procedure after about 2 seconds. When starting manually, please press the START button. The
banknotes are counted and transported via the banknote ejection into the tray compartment. The counting result
can be read off the display.

Cleaning of the machine

Before cleaning the machine, switch it off and remove it from the power source. Do not use liquid cleaners to
clean the machine. We recommend the use of a compressed air spray.
1.
Cleaning the optical sensor: It is important to clean the sensors regularly to prevent paper or dust particles
from settling.
2. Cleaning the inside of the machine: The inside of the machine should be cleaned once a month. Turn off the
machine and simply open the lid to access the interior.
3. Further recommendation: Do not use the machine in dusty or dirty areas. Always protect the machine from
dirt when it is not in use.
[ EN]
9

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis