Start-Up; Status Displays - G&D DP-MUX2-USB Installation Und Bedienung

Start-up

Start-up
Turn on the Power switch on the back panel of the KVM switch.
As soon as the device is supplied with power, the green User LED lights up. The
KVM switch is now ready for use.

Status displays

The LEDs on the front panel of the device enable you to control the operational status
at all times.
Section
CPU 1 ... 2
User
8 · G&D DP-MUX2-USB
Downloaded from www.Manualslib.com
LED Status
Active on
flashing
off
Status on
off
Active on
slow
blinking
blinking
Status on
off
manuals search engine
Meaning
All inputs are forwarded to the computer of this channel.
In the default settings of the KVM switch, data of devices
connected to the »USB 2.0 Devices« interface are for-
warded to the computer of this channel, too.
An additionally flashing Active LED (see below) of
another channel shows that USB data is permanently
switched to another channel.
The devices connected to the »USB 2.0 Devices« interface
are permanently switched to this channel (Pinning).
The channel is currently inactive.
The computer is ready for operation.
No computer is connected or the computer is turned off.
The keyboard is properly and completely initialised.
The LED blinks after the device is turned on and until the
keyboard is initialised
The setup mode of the KVM switch is active.
The KVM switch is supplied with the necessary voltage.
The KVM switch is turned off or is not supplied with the
necessary voltage.
If necessary, check the proper connection of the power
supply cable.