Connecting The Console Devices - G&D DP-MUX2-USB Installation Und Bedienung

Connecting the console devices

ADVICE:
block and from the bottom up. By doing so, you will avoid already connected
cables blocking your view of the interfaces.
Keyb./Mouse Line In Speaker
Figure 2: Interfaces to connect the console devices
Keyb.:
Mouse:
IMPORTANT:
on the front panel of the device.
In this case, switching of the channels is not possible via keyboard!
Line In:
Speaker:
active computer.
NOTE:
DP Monitor
NOTE:
of computers in a multi-monitor installation can be transmitted to two monitors.
Connect the second monitor to the
MC2 variant.
DP Monitor:
DVI-D-Monitor:
USB 2.0 Devices:
(e.g. a printer or a mass storage device), connect these devices to the interfaces on
the front panel (see figure 1 on page 4).
Downloaded from www.Manualslib.com
Connect the cables of the console and the computers preferably block by
DVI-D Monitor DP Monitor
CON CPU 1
Line In Line Out
Plug the connection cable of the USB keyboard in this interface.
Plug the connection cable of the USB mouse in this interface.
You can also connect both input devices to the
If desired, connect a microphone or a headset to this interface.
Connect the speakers to this interface for output of audio signals at the
You can use either a DisplayPort cable to connect the monitor to the
socket or a DVI cable to connect it to the
When deploying a MC2
Plug the monitor's DisplayPort cable to this interface.
Plug the monitor's DVI-I cable to this interface.
If you want USB devices to be available to the connected computers
manuals search engine
DP CPU 1 DP CPU 2
CPU 2
USB 2.0 Line In Line Out USB 2.0
variant of the KVM switch, the separate video signals
or
DP Monitor 2
Installation
interfaces
USB2.0 Devices
socket.
DVI-D Monitor
interface of the
DVI-D Monitor 2
G&D DP-MUX2-USB · 5