Herunterladen Inhalt Inhalt Diese Seite drucken

Important Safety Instructions - Abus TVAC26030 Installationsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Important Safety Instructions

Damage caused by not following these operating instructions will invalidate the
warranty. We assume no liability for consequential damages!
We assume no liability for damage to property or personal injury caused by improper
handling or failure to observe the safety instructions. In such cases, any claim under
warranty will be void!
Dear customer,
the following safety and hazard warnings serve not only to protect your health, but also to protect
the device. Please read the following points carefully:
There are no parts inside the product that need to be maintained. In addition, opening/dismantling
will invalidate the approval (CE) and the guarantee/warranty.
Falling from an already low height can damage the product.
Avoid the following adverse environmental conditions during operation:
Wetness or too high air humidity
Extreme cold or heat
Direct solar radiation
Dust or combustible gases, vapours or solvents
strong vibrations
strong magnetic fields, such as near machines or loudspeakers
The Keyboard must not be installed on unstable surfaces.
General safety instructions:
Do not leave the packing material lying carelessly! Plastic foil/bags, polystyrene parts etc. could
become dangerous toys for children.
For safety reasons, the Keyboard must not be placed in the hands of children due to small parts
that could be swallowed.
Please do not insert any objects through the openings into the interior of the device
Use only the accessories/accessories specified by the manufacturer. Do not connect incompatible
products.
Please observe the safety instructions and operating instructions of the other connected devices.
Check the device for damage before commissioning. If this is the case, please do not put the
device into operation!
Observe the limits of the operating voltage specified in the technical data. Higher voltages can
destroy the device and endanger its safety (electric shock).
When installing in an existing video surveillance system, make sure that all devices are
separated from the mains and low-voltage circuits.
If in doubt, do not carry out the assembly, installation and wiring yourself, but leave this to a
specialist. Improper and unprofessional work on the power supply system or on the house
installations is not only a danger for yourself but also for other persons.
Wire the installations so that the mains and low-voltage circuits are always separate and are
not connected at any point or can be connected by a defect.
4

Werbung

Kapitel

Inhaltsverzeichnis
loading

Inhaltsverzeichnis