Changing A Programme; Checking Programme Values - Pyrotec D1 Bedienungsanleitung

Changing a Programme

T
2
+
-

Checking Programme Values

16
Downloaded from www.Manualslib.com
¡C
h : min
manuals search engine
When the firing is completed successfully the
PYROTEC D1 reads „EndE" alternating with the actual
kiln temperature. Wait until the kiln has cooled down
naturally before opening.
The following example explains how to change the
firing temperature of programme P2 from its original
value of 900°C to 850°C.
Select programme P2 as described in the example
before. After pressing key (6) the display (1) shows the
current value of the programme (900°C). The
corresponding indicators in firing curve (9) light up.
Use keys (3) to alter the value to 850°C. Keep the key
pressed for large changes in value. Changing the other
values of the firing works the same way. Press one of
the keys (6, 7, 8, 10) to show the current programme
value in display (1) and adjust the value using keys (3)
if required.
The programme change is done permanent, ie. is also
kept when the controller is powered down. However,
all programme values can be changed as often as you
like.
To start the firing with the new firing curve simply
press key (12).
All programme values can be checked by pressing
the corresponding key (6, 7, 8, 10). This can be done
at anytime also during a firing process without
interrupting the firing process.
Display (1) reads the programme value for 2 seconds
before returning to the actual kiln temperature. As
well the corresponding indicator of the firing curve (9)
is blinking during displaying the programme value.