Firing Curves; Programmes - Pyrotec D1 Bedienungsanleitung

14
Downloaded from www.Manualslib.com

Firing Curves

Programmes

manuals search engine
The PYROTEC D1 microprocessor controller allows
an exact and reproduceable control of your kiln. A
firing curve consists of the segments (a) to (d).
Example:
Temp
(°C)
900
600
6:00
Segment
a
heating up to 1st temperature (a):
The kiln heats up at the set rate. Rate is entered by the
time to reach the temperature (600°C in the example).
heating up to final (firing) temperature (b):
Kiln heats up at maximum power to firing temperature.
dwell at final temperature (c):
The kiln temperature remains at the final temperature
for the set time. This is to ensure that all fired goods
are entirely heated through.
programme end resp. uncontrolled cooling (d):
After completing dwell the kiln cools down naturally.
The PYROTEC D1 comes with 5 typical firing curves,
programme no. 1 (P1) to programme no. 5 (P5). You
can adapt these programmes according to your needs.
The programmes are factory set as follows:
0:10
b c d