Hisense RQ689N4AF2 Benutzer-Bedienungsanleitung Seite 39

Door seals cleaning
Take care to keep door seals clean.
Sticky food and drinks can cause seals
to stick to the cabinet and tear when
you open the door. Wash seal with a
mild detergent and warm water. Rinse
and dry it thoroughly after cleaning.
Caution! Only after the door seals are
completely dry should the appliance be
powered on.
Replacing the LED light:
Warning: The LED light must not be
replaced by the user! If the LED light is
damaged, contact the customer
helpline for assistance. To replace the
Defrosting
Water contained in the food or getting into air inside the fridge by opening doors may
●
form a layer of frost inside .It will weaken the refrigetation when the frost is thick.
● This appliance is frost-free refrigerator, Automatic defrost itself regularly, without
manual defrost.Water from defrosting will be drained into an drip tray through a drain
pipe,Then the water within the drip tray will be evaporated.
LED light, the below steps can be
followed:
1. Unplug your appliance.
2. Remove light cover by pushing up
and out.
3. Hold the LED cover with one hand
and pull it with the other hand while
pressing the connector latch.
4. Replace LED light and snap it
correctly in place.
16