Filter Reset - Philips 1000i Serie Benutzerhandbuch

Filter alert light Action
status
Replace
A3 displays on
NanoProtect filter
the screen
Series 3 (FY1410)
Replace
NanoProtect filter
C7 displays on
the screen Active Carbon
(FY1413)
A3 and C7
display on
Replace both filters
the screen
alternately
1
Turn off the air purifier and unplug
from the power socket.
2
Take out the used air filter according
to the filter alert light status
displayed on the screen (Fig.y).
Discard used filters.
Note
• Do not touch the pleated filter surface,
or smell the filter as it has collected
pollutants from the air.
3
Remove all packaging material from
the new filter (Fig.f).
4
Place the new filters into the air
purifier (Fig.g).
5
Put the plug of the air purifier in the
power socket.
6
Touch and hold the
to reset the filter lifetime counter
(Fig.z).
7
Wash your hands after changing a
filter.
12 EN

Filter reset

You can replace filters even if there is
no filter replacement code displayed on
the screen. After replacing a filter, you
need to reset the filter lifetime counter
manually.
1
2
3
4
for 3 seconds
Touch and simultaneously
for 3 seconds to enter the filter reset
mode (fig.{).
» Code (A3) of the NanoProtect
filter Series 3 displays on the
screen.
Touch and hold for 3 seconds to
force reset the filter lifetime counter
of the NanoProtect filter Series 3
(fig.z).
Code (C7) of the Nanoprotect filter
Active Carbon displays on the
screen after the lifetime counter of
the NanoProtect filter Series 3 has
been reset (fig.|).
Touch and hold for 3 seconds to
force reset the filter lifetime counter
of the NanoProtect filter Active
Carbon and exit the filter reset
mode (fig.}).