Getting Started; Powering On And Off; Switching Mode - AKASO Brave 6 Plus Bedienungsanleitung

11
1 Shutter/Select Button
Power/Mode/Exit Button
2
3 Up/Wi-Fi Button
4 Down Button
5 Speaker
6 Lens
Note: Camera does not record sound when it is in the waterproof case.
03
7 USB Type-C Port
8 Micro HDMI Port
9 Touch Screen
Battery Door
10
MicroSD Slot
11

GETTING STARTED

Welcome to your AKASO Brave 6 Plus. To capture videos and photos, you need a
microSD card to start recording (sold separately).
MICROSD CARDS
Please use brand name memory cards that meet these requirements:
• microSD, microSDHC or microSDXC
• UHS-III rating only
• Capacity up to 64GB (FAT32)
Note:
1. Please format the microSD card first in this camera before using. To keep your
microSD card in good condition, reformat it on a regular basis. Reformatting
erases all your content, so please make sure to offload your photos and videos
before reformatting.
2. FAT32 format microSD card stops recording when the file size reaches to 4GB,
and starts to record again on a new file.

POWERING ON AND OFF

To Power On:
Press and hold the Power button for 3 seconds. The camera beeps while the camera
status light is on. When information appears on the display, your camera is on.
To Power Off:
Press and hold the Power button for 3 seconds. The camera beeps while the camera
status light is off.

SWITCHING MODE

To Switch Mode:
Turn on the camera, swipe your finger across or up the screen to change modes.
TURNING ON AND OFF Wi-Fi
Turn on the camera, press Up button to turn on Wi-Fi, and press again Up button to
turn off Wi-Fi.
04