Memory Function; Saving The Reading; Recalling Stored Data (Display); Deleting Stored Data - Terraillon PRESSIO W Bedienungsanleitung

54120_S_Pressio W-V10.qxd 6/09/05

8 Memory function

8.1 Saving the reading

• Your "Pressio W" can store data from up to 60 measurements.
• Once the 60 measurements are recorded, each subsequent reading replaces
the "oldest" in the memory.

8.2 Recalling stored data (display)

• To recall the memory, press "MEM" button first. Then, the average result of all stored
measurements will be shown on the LCD first.
• After the average reading is shown on the display, you can press "MEM" button to track
historical records from no.1 to no.60.
Pr e s s
" M E M " " M E M "
• To come back to the first records, please press "SET" button.
This function is available only after readings have been saved to memory!
If no data has been stored, the display will go directly to the "setting time
and date" function.

8.3 Deleting stored data

While in power off mode, press "MEM" button and hold it until the screen
shows "Clr".
26
13:49 Page 26
Pr e s s

9 Care and maintenance

9.1 Care and maintenance
• If necessary, clean the plastic housing and cuff with a slightly moistened
cotton cloth.
• Do not disassemble, repair or remodel the monitor.
• Do not expose the monitor to extreme temperature, very high humidity,
or direct sunlight.
• Avoid dropping and rough handling.
• Do not immerse the device in water. It may cause damage i f water enters.
• Do not use any gas, strong detergent, or solvents to clean the device,
including the arm cuff.
• Batteries should not be discarded with domestic waste!
Please dispose of batteries only in the disposal bins provided in shops.

9.2 Changing the cuff

If you need a new cuff for your "Pressio W", this can be obtained from Terraillon
as an accessory. For technical reasons, the cuff should only be changed by Terraillon.
Please consult your dealer if necessary.
27