Adjustment Mode / Check Alignment; The Adjustment Mode Is Finished - Fiessler Razl-2Co Handbuch

People Counter RAZL-2CO (Translation)

2.7 Adjustment mode / Check alignment

The pillars are correctly aligned when the dimension of the cover from the left and from the right is approximately the same until the corresponding color
flashes. The cover template should be removed before checking the alignment.
Correct
Cover the reflector directly in front of the column slowly as in the pictures
below until the traffic light flashes white.
If the traffic light already flashes white at minimum coverage, the
sensor pillar must still be turned slightly counterclockwise.

2.8 The adjustment mode is finished.

The sensor pillar is ready for person detection.
Traffic light
The cover template must be removed after exiting the adjustment mode.
shines
green
The adjustment mode can be activated and deactivated manually via the menu. If the adjustment mode is activated manu-
ally, the mode remains active until it is deactivated manually again.
Fiessler Elektronik GmbH & Co. KG
Buchenteich 14, D-73773 Aichwald
Cover the reflector directly in front of the column slowly as in the pictures
If the traffic light is already flashing yellow at minimum coverage, the
-22-
Phone: +49 (0)711 - 91 96 97 - 0
Fax: +49 (0) 711 - 91 96 97 - 50
Correct
below until the traffic light flashes yellow.
sensor pillar must still be turned slightly clockwise.
Internet: http://fiessler.de
E-Mail: info@fiessler.de