Connection Cable; Optional Switching Output; Starting Up - FIESSLER RAZL-2CO Handbuch

People Counter RAZL-2CO (Translation)

2.3 Connection cable

The sensor pillar is connected via a 4 m long connection cable with an earthed plug and via a 4 m long cable for the switching output (optional).
For connection, the cables must be pulled out of the opening in the base of the sensor pillar.
The connection cable for the switching output can remain in the stand when not in use.
If the cables are too long, the excess cables can be stored in the opening in the base of the sensor pillar.

2.4 Optional switching output

The reflector pillar is optionally available with a switching output.
With the optional switching output, for example, an automatic door can be released, or blocked if the permitted number of persons is exceeded.
1
2
3
Release
Blocking when the allowed
number of persons is exceeded

2.5 Starting up

After plugging the connection cable into a 230 V earthed socket, the traffic light is illuminated blue during the starting process ca. 1 minute.
The adjustment mode for aligning the pillars is then activated.
In adjustment mode, the column flashes in the appropriate color depending on the alignment of the pillars.
When the traffic light flashes green, the adjustment mode is automatically terminated after 30 s without covering the pillars (does not apply if
the adjustment mode is activated manually via the menu).
see next section "Adjustment mode / Alignment of the pillars"
Fiessler Elektronik GmbH & Co. KG
Buchenteich 14, D-73773 Aichwald
1 and 2 are connected
2 and 3 are not connected
1 and 2 are not connected
2 and 3 are connected
Phone: +49 (0)711 - 91 96 97 - 0
Fax: +49 (0) 711 - 91 96 97 - 50
-20-
Internet: http://fiessler.de
E-Mail: info@fiessler.de