Philips PerfectDraft HD3620 Bedienungsanleitung Seite 18

EnglisH
18
Be careful of the paste on the cooling element and adjacent parts. If this
paste ends up on your clothes, it causes a permanent stain.
Remove the cooling element in the following way:
1 Unplug the appliance.
 Slide the release button to the right to open the doors.
There are two holes near the hinges of the doors on either side.
,
 Remove the four screws located in these holes with a screwdriver.
 Remove the back cover from the appliance.
5 Pull the cooling fan out of the appliance.
Now you see an aluminium plate with fins on it and with two screw
,
holes.
6 Undo the screws with a screwdriver.
 Remove the aluminium plate.
After you have removed the aluminium plate, you see a white plate
,
of approx.  x cm. This is the actual cooling element.
8 Place the flat blade of a screwdriver behind the cooling element.
Twist the screwdriver to pry the cooling element off the back of the
aluminium plate.
 Cut the wires attached to the cooling element.
Do not connect the appliance to the mains again after you have removed
the cooling element.
Never reassemble the cooling element once you have removed it.