Philips 7000 SensoTouch Serie Handbuch Seite 25

Problem
The shaver does not
work when I press the
on/off button.
RQ1197CC,
RQ1195CC,
RQ1185CC,
RQ1180CC,
RQ1175CC only: The
shaver is not entirely
clean after I clean it in
the Jet Clean System.
RQ1197CC,
RQ1195CC,
RQ1185CC,
RQ1180CC,
RQ1175CC only: The
Jet Clean System does
not work when I press
the on/off button.
Possible cause
The rechargeable battery is empty.
The travel lock is activated.
The shaving head holder is soiled or
damaged to such an extent that the
motor cannot run.
The temperature of the shaver is too
high. In this case, the shaver does not
work.
The cleaning fluid in the cleaning
chamber is soiled.
The cleaning fluid level is too low.
If the fluid volume in the cleaning
chamber drops below the minimum
level during the cleaning program, the
program aborts.The cleaning light and
the 'cleaning chamber empty' symbol
flash at intervals and the holder
returns to its starting position.
You have used another cleaning fluid
than the original Philips cleaning fluid.
The Jet Clean System is not
connected to the mains.
There is no electrical connection
between the Jet Clean System and the
shaver.
ENGLISH
Solution
Recharge the battery (see chapter
'Charging').
Press the on/off button for 3 seconds
to deactivate the travel lock.
Clean the shaving head holder or
replace it (see chapters 'Cleaning and
maintenance' and 'Replacement').
Let the shaver cool down. As soon
as the temperature of the shaver has
dropped sufficiently, you can switch
on the shaver again.
Empty and rinse the cleaning
chamber and refill it with new
cleaning fluid.
Refill the cleaning chamber with
cleaning fluid to a level between the
two lines (see chapter 'Cleaning and
maintenance').
Only use HQ200 Philips Cleaning
Fluid.
Put the small plug in the Jet Clean
System and put the adapter in the
wall socket.
Press the shaver tightly into the
holder to lock it into place.
25