JUMO variTRON 500 Montageanleitung Seite 56

2 Mounting
Dismounting of the central processing unit 705002
Process:
1. Remove the connecting cables if required (interfaces).
2. If required, use a screwdriver to release the wired terminal (E) of the central processing unit (A) and
pull off toward the front (E1).
3. Fully release the end bracket (D) using a screwdriver (D2), press upward from below, pivot toward
the front, and remove from the DIN rail.
Note: The end bracket does not need to be removed from the DIN rail if there is sufficient space to
the side to move it at least 10 mm to the right.
4. Move the cover (C) to the right (C3) until the side contacts of the neighboring module are exposed.
Then release the cover at the bottom using a screwdriver, press upward, and remove from the DIN
rail.
18
(A)
(A7)
(E)
(E1)
(F6)
(B) (B) (C) (D)
(B4) (B4) (C3)
(A)
(A5)
(F)
(D2)