Cleaning Of The Spark Plug; Periodic Maintenance; Troubleshooting - AEG HG654320NM Benutzerinformation

38 www.aeg.com
• Be very careful when you replace
the pan supports to prevent the hob
top from damage.
After cleaning, dry the appliance with a
soft cloth.
Removing the dirt:
1. – Remove immediately: melting
plastic, plastic foil, and food con-
taining sugar.
– Stop the appliance and let it
cool down before you clean: lime-
scale rings, water rings, fat stains,
shiny metallic discolorations. Use a
special cleaner applicable for sur-
face of hob.

7. TROUBLESHOOTING

There is no spark when
lighting the gas
The flame is blow out im-
mediately after ignition
Problem
2.
3.
The stainless steel can become tarnished
if it is too much heated. Refer to this you
must not cook with potstones, earthen-
ware pans or cast iron plates.

6.1 Cleaning of the spark plug

This feature is obtained through a ce-
ramic ignition candle with a metal elec-
trode. Keep these components well
clean to prevent difficult lighting and
check that the burner crown holes are
not obstructed.

6.2 Periodic maintenance

Periodically speak your local Service
Force Centre to check the conditions of
the gas supply pipe and the pressure ad-
juster, if fitted.
Possible cause
• There is no electrical
supply
• Burner cap and crown
are placed uneven
• Thermocouple is not
heated sufficient
Clean the appliance with a damp
cloth and some detergent.
At the end rub the appliance dry
with a clean cloth.
Remedy
• Make sure that the
unit is connected and
the electrical supply is
switched on.
• Control the fuse. If the
fuse is released more
than one time, refer to
a qualified electrician.
• Make sure that the
burner cap and crown
are in correct posi-
tions.
• After lightning the
flame, keep the knob
pushed for approxi-
mately 5 seconds.