Herunterladen Inhalt Inhalt Diese Seite drucken

Kostal PIKO 10 Kurzanleitung Seite 22

Vorschau ausblenden Andere Handbücher für PIKO 10:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 4
Short manual
IMPORTANT INFORMATION
The inverter may only be installed, maintained and repaired by a trained and qualified elec-
trician. The electrician is responsible for ensuring that the applicable standards and regu-
lations are observed and implemented. Work that could affect the electrical power system
of the relevant energy supply company at the site of the solar power feed-in, may only be
carried out by qualified electricians expressly authorised (licensed) by the energy supply
company. This includes changes to the factory pre-set parameters in the inverter, which can
be changed using the Webserver.
It must be ensured that the L1-L3 phases on the inverter's AC terminal and the phases in the
grid are assigned uniformly.
This product may generate a direct current in the outer protective earthing conductor. If
protective residual current devices (RCD) or residual current monitoring devices (RCM) are
used, only type B RCDs or RCMs are permitted on the AC side.
The solar modules connected to the inverter must comply with Class A of the IEC 61730
standard.
For the time it takes to complete initial commissioning, there must be sufficient PV energy
(at least "Min. input voltage (U DCmin)") on the inverter. Should the voltage or necessary
power fall below the required level during initial commissioning, the inverter will switch off.
POSSIBLE DAMAGE
Risk of damage when the inverter is placed on its underside. Always place the inverter on its
rear side (cooling elements) after unpacking.
If the PV generators are incorrectly connected, the inverter may be damaged. Check the
connections before commissioning.
Installation
Perform inverter assembly, installation and commissioning based on the information provided in the
Installation chapter on page 64 onwards
Complete operating manual and warranty conditions
You can find a detailed operating manual for the PIKO inverter and approved energy meters online at
www.kostal-solar-electric.com > Download > Product category > Model > Country >
Operating manual
Information about the service and warranty conditions is provided in a separate document available at
www.kostal-solar-electric.com > Download > Product category > Model > Country >
Warranty
22
.
© 2020 KOSTAL Solar Electric GmbH

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Piko 20

Inhaltsverzeichnis