Toshiba RAV-SM562CT-E Installations-Handbuch Seite 27

Procedure
6
7
To recognize the position of the corresponding
indoor unit though the indoor unit No. is known
Check the position during operation stop.
(Be sure to stop operation of the set.)
Procedure
1
2
3
Downloaded from www.Manualslib.com
If there is other indoor unit to be changed, repeat
2 5
procedure to to change the setup.
When the above setup has finished, push
select the indoor unit No. before change of setup, specify
ITEM CODE [12], [13], [14] in order with temp. setup
/ buttons, and then check the changed contents.
Address change check Before change:
[3-3-1] → After change: [2-2-2]
Pushing CL button clears the contents of which setup was changed.
2
(In this case, procedure from
After check of the changed contents, push
display disappears and the status becomes the usual stop status. (When pushing
from the remote controller is not accepted for approx. 1 minute.)
* If the operation from the remote controller is not accepted even
1 minute or more passed after pushing
considered that the address setup is incorrect.
In this case, the automatic address must be again set up.
Therefore repeat procedure of the setup change from the Procedure
VENT
TEST
Push simultaneously +
After a while, the display part flashes and the display appears as shown below.
In this time, the position can be checked because fan and flap of the indoor unit operate.
• For the group control, the indoor unit No. is displayed as [
fans and flaps of all the indoor units in the group control operate.
Check the displayed ITEM CODE is [01].
• When the ITEM CODE is other than [01], push
erase the display and repeat procedure from the first step.
TEST
(After pushing button, operation of the remote controller
is not accepted for approx. 1 minute.)
In the group control, every pushing
In this time, the position of the indoor unit can be confirmed because only fan and flap of the selected indoor
unit operate. (For a group control, No. of the firstly displayed indoor unit becomes the header unit.)
TEST
After confirmation, push button to return the mode to the
usual mode.
TEST
When pushing button, the display disappears and the status
becomes the usual stop status.
TEST
(When pushing button the operation from the remote controller
is not accepted for approx. 1 minute.)
manuals search engine
Description
Indoor unit No. before setup change is displayed.
UNIT
to
is repeated.)
TEST
button. (Setup is determined.) When pushing
TEST
button, it is
Description
buttons for 4 seconds or more.
ALL
TEST
button to
UNIT
button, the indoor unit No. in the group control is displayed in order.
24
SET DATA SETTING TEST
UNIT No.
R.C. No.
SET DATA SETTING TEST
UNIT No.
R.C. No.
SET DATA SETTING TEST
UNIT No.
R.C. No.
TEST
button, the
TEST
button the operation
1
.
SET DATA SETTING TEST
UNIT No.
R.C. No.
TEMP. ON / OFF
TIMER SET FAN
TIME SWING/FIX
FILTER
RESET TEST SET CL UNIT
3
] and
∗
SET DATA SETTING TEST
UNIT No.
R.C. No.
∗
( Display changes according
to the model No. of indoor unit.)
CODE No.
CODE No.
CODE No.
CODE No.
MODE 1
VENT
2
CODE No.