Toshiba RAV-SM562CT-E Installations-Handbuch Seite 13

Connection of drain hose
• Insert the attached drain hose into the drain pipe
connecting port on the drain pan up to the end.
• Fit the attached hose band to the end of the pipe
connecting port, and then tighten it securely.
• Be sure to fix the drain hose with the attached
hose band, and set the tightening position
upward.
• As the draining is the natural water draining,
arrange the pipe outside of the unit on the down
slope.
• If piping is performed as shown in the figure,
drain cannot be discharged.
Fit the attached hose band to the end of the hose,
lay down the knob, and then tighten hose band.
Drain pan
Confirm that soft hose is pushed
in up to the end of the drain pan.
Downloaded from www.Manualslib.com
REQUIREMENT
NO GOOD
Refrigerant pipe
Drain pipe
Drain pipe
Attached drain hose
manuals search engine
Thermal insulating process
• Using the attached drain hose thermal insulator, lap
the connecting section and the drain hose without
clearance, and then tighten with two handing band
so that thermal insulator does not open.
• Covering the attached drain hose thermal insulator,
lap the thermal insulator (procured locally) to the
drain pipe without clearance.
Lap covering connecting section
between drain pan and drain hose.
Drain hose
Drain
pan
Hose band Banding band
Attached thermal insulator
* Tighten the banding band so that attached
thermal insulator is not pushed excessively.
Connection of drain pipe
• Connect the hard vinyl chloride pipe (procured
locally) to the mounted drain hose which was
attached.
• In case of taking pipe from the left side
• In case of taking pipe from the left side, exchange
the plug from left to right. Push in the plug of which
end is not sharp up to the end.
10
Thermal insulator
(procured locally)
Lap the attached
Hose band
thermal insulation so
that the one end is
put on the other end
at the upper side.
Drain pan
Pulg