Rear Panel
The rear panel includes a three-prong universal power plug. The input
power is 100-240V AC /50-60Hz.
Placement options
Place the GigaX1016 Switch on a flat and stable surface. Make sure the
location meets the operating environment specifications. See page 6 for
details.
Connecting network devices
Follow these steps to connect network devices to the GigaX1016 Switch:
1. Connect one end of the Ethernet cable to an Ethernet port on the Switch
2. Plug one end of the power cable to the power connector on the Switch
3. The Power LED and LED indicators for active Ethernet ports light up to
4
Downloaded from
www.Manualslib.com
NOTE: The maximum cable length of UTP Category 5 is 100 meters
(328 feet).
front panel. Connect the other end to the Ethernet port of the network
device. Repeat this step to connect additional network devices.
rear panel, then plug the other end to an electrical outlet.
indicate that the device is on and in use. Refer to the LED table in page
3 for indications.
manuals search engine
Figure 3. Rear panel