Operation - Klarstein Smartwave Handbuch

EN
28

OPERATION

Warning: Danger of personal injury
This heater is not equipped with a device to control the room
temperature. Do not use this heater in small ro oms when they
are occupied by persons not capable of leaving the room on
their own, unless constant supervision is provided.
1. Plug the heater power cord into the socket that matches the voltage and current of
the body nameplate.
2. Press the switch button to open the heater.
3. Press the gear button to select the gear position, a total of four gear power
selection, the gear position indicator icon displays the corresponding gear position
symbol.
4. Press the Up/Down button to select the setting temperature. The temperature setting
range is 5-45 degrees.
5. Press the time button to enter the timing setting state. Select the timed shutdown
time by the up/down button. The timing range is 0-24 hours. The timing indicator is
illuminated when the timer is running.
6. Press the on-screen button once, the digital screen only displays the temperature,
and press the digital screen twice to display only the heating symbol.
7. Press the intelligent heating button, the heater enters the intelligent heating mode,
the gear position will automatically switch according to the temperature change,
and the intelligent heating operation indication icon will light when the intelligent
heating mode is running.
8. According to the human body sensing button, the heater enters the human body
sensing mode, and the heater heats up when the warming device detects a moving
object. Not detected, the heater stops heating after two minutes, and the human
body sensing operation indicator lights up when the human body sensing mode is
running.
9. Press the switch button and then press the child lock button, the heater is locked,
press any button, no response.
Unlock: Press the toggle button and then the child lock button.
10. Press the switch button and then press the up button to switch between Fahrenheit
and Celsius.
1 1. Press the toggle button and then press the button to reset the WI-FI.
12. Press the switch button and then press the gear button to select the window
detection function. When the window detection function is running, the WO lights
up. When the heater detects that the ambient temperature drops by 3 degrees in
two minutes, it stops heating. At this time, the window detection operation indication
icon is lit.
13. Press the toggle button and then press the display button to display the voltage.
14. Press the on/off key again to shut down.