Swap Function; Establish Swap Channel (Preferred Channel); Reverting To The Factory Setting - Medion md 30022 Bedienungsanleitung

S F
WAP UNCTION
The Swap Function enables you to change between two channels positioned separately or
to switch back to a preferred channel fast. For example, if you want to switch channels dur-
ing an advertising break, you can switch back quickly at any time, by pressing the RTN
Button, to see whether the advertising break has already finished and your desired pro-
gram is continuing. Each further operation of the RTN Button will lead to a switch between
the channel most recently viewed and your preferred channel.
E
STABLISH SWAP CHANNEL
Variation 1: Press the MENU Button to call up the Main Menu. Position the Selection Bar on
SWAP FUNCTION by means of the
Button again. You can choose between MANUAL/ 3 MIN/ 5 MIN/ 10 MIN set-
tings with the
by means of the MENU Button.
The Swap Channel must be defined in accordance with Variation 2 in the case
of the MANUAL setting. The channel viewed is automatically defined as the
Swap Channel after the period has expired whenever a period of time is set.
SWAP CH will be faded in into the left upper corner. Now, you will be able to
select any other channel slot and switch between the channel viewed and your
Swap Channel by pressing the RTN Button for a short time. The channel that is
your preferred channel will be displayed for 4 seconds at each channel change.
Variation 2: Press on the channel slot to which you want to revert quickly as long as the
RTN Button appears, until SWAP CH OSD is faded in. You will now have estab-
lished your preferred channel manually.
However, if a period of time has been set in the SWAP FUNCTION Menu, your
preferred channel will change automatically with your television viewing.
R
EVERTING TO THE
This function sets all settings of the TV, such as brightness, colour, contrast, sharpness and
white balance, etc. back again to the status of delivery from the factory.
1. Press the MENU Button to reach the Main Menu.
2. Select the INSTALLATION Point with the
ton again.
3. Select the FACTORY SETTINGS Point with the
Button again. Now, select SET and confirm this selection with the MENU Button.
Note: You can set most important picture and sound (brightness, colour, contrast, volume)
settings back to the factory settings by pressing the RST, RESET Button for a longer pe-
riod.
32
(P
REFERRED CHANNEL
VOL-/VOL+ Buttons or through a Menu that can be reached
F S
ACTORY ETTING
E E
N N G G L L I I S S H H
)
P+/P- Buttons and press the MENU
P+/P- Buttons and press the MENU But-
P+/P- Buttons and press the MENU