auna MD-210 BT Handbuch Seite 16

On/off
Mode selection
Loudness
Mute
Volume
Bass
Treble
Balance
Fader
DSP EQ mode
Beep
Standard Volume
Clock
Band Select
Manual Station
Scan
16
Downloaded from www.Manualslib.com
Press POWER to turn the device on or off.
Press MODE to select from the different modes.
Press SEL repeatedly until the display shows LOUD ON or LOUD OFF. Turn the volu-
me knob to select out of these options (press SEL to confirm).
Press MUTE to mute or unmute the audio output.
Turn the volume knob clockwise to increase, anti-clockwise to decrease the volume.
Press SEL repeatedly until the display shows BAS. Turn the volume knob to adjust
the bass. (Inactive when in DSP mode)
Press SEL repeatedly until the display shows TRE. Turn the volume knob to adjust the
treble. (Inactive when in DSP mode)
Press SEL repeatedly until the display shows BAL. Turn the volume knob to adjust
the stereo balance.
Press SEL repeatedly until the display shows FAD. Turn the volume knob to adjust
the fader.
Press SEL repeatedly until the display shows EQ. Turn the volume knob to select
from FLAT, ROCK, POP or CLASS. In FLAT mode, DSP is set inactive.
Press SEL repeatedly until the display shows BEEP. Turn the volume knob to adjust
the keys „beeps" or deactivate completely.
Press and hold SEL for 2 seconds untin TA ALARM is displayed. Then, press SEL
repeatedly until P_VOL is displayed. Adjust by turning the volume knob (standard
output volume when turning the device on).
Press and hold CLK to display the time. Keep holding, until the time display starts
flashing.
By turning the vol knob you can now change the hour. Press SEL to process to chan-
ging the minutes. After successfully changing the displayed time, press CLK to save
and confirm.
Press BND repeatedly to select from band FM1, FM2, FM3, AM1, AM2.
Press Back/Next to manually scroll through the frequencies by steps of 0.05Mhz.
Press and hold for automatically scaning to the next available/receptable station.
manuals search engine
Operation
Basics
FM Radio