For Your Safety; Lighting - Atag WS90MM Serie Gebrauchsanweisung/Installationsvorschrift

for your safety

please note
This appliance should be connected by a
registered fitter. Damage arising from incorrect
connection or incorrect fitting is not covered by
the guarantee.
Disconnect the appliance before starting with
cleaning or reparation. It is recommended that
you do this by removing the plug from the
socket or by setting the isolation switch to zero.
Never flambe under an extractor. The high
flames can cause fire. Even if the ventilator is
switched off.
When deep-frying, always keep a close watch.
If the appliance is used together with
equipment which uses gas or other fuels, then a
sufficient supply of fresh air must be ensured.
Switch the extractor hood on before starting to
cook. After cooking, allow the extractor hood to
continue to run for approx. 10 minutes. This can
also be done automatically (see 'automatic
continued running').
Clean the appliance regularly, as shown in
'maintenance'. This minimises the chance of a
fire starting.
Switch off the electricity before replacing the
light bulbs! Only use the same sort of light bulbs
with the same Wattage.
GB 2
In view of possible sharp edges on the chimney
we advise you to wear working gloves when
fitting the chimney.

lighting

2 3 4
1
switching lighting on and off
Press the lighting button
The lighting comes on at its highest setting.
Press the button again and the lighting is dimmed.
Press the button for a third time and the lighting goes out.
The indicator light in the button also goes out.
fan
switching on the fan
Press the
The extractor hood comes on at the setting selected. The
figure in the button lights up.
adjusting the extractor capacity
Press a button with a higher or lower value.
The figure in the button lights up.
intensive setting
Press the
The figure in the button lights up.
.
1 3
2
, or button.
4
button.
GB 3