Installation; Startup - Guntermann & Drunck MultiPower-12-NT Installationsanleitung

Installation

Installation
NOTE:
The maximum power consumption permitted per device is 800 mA.
1. Use a power loop cable to connect one of the
compatible devices (12VDC/800mA) to one of
the twelve
2. Connect one of the supplied power cables to the
Main Power
Connect the power cable to a power outlet.
3. If necessary, connect one of the supplied power
cables to the
redundant power supply.
Connect the power cable to a power outlet of another power circuit.

Startup

1. Turn on the power switch of the internal
2. Turn on the power switch of the internal
NOTE:
tral power supply are started. Within approx. 60 seconds the outputs are turned
on successively.
3 · G&D MultiPower-12-NT
Downloaded from www.Manualslib.com
The MultiPower-12-NT supplies up to twelve devices with 12 Volt.
sockets.
Power Out
socket.
Red. Power socket to establish a
After you turn on the central power supply, the internal services of the cen-
manuals search engine
Power Status
M
Power Out 1 Power Out 2
Status Status
12VDC/800mA 12VDC/800mA
Main Power
Main Power power pack.
Red. Power power pack.
P -12-
ULTI OWER NT
Power Out 3
Status
12VDC/800mA 12VDC/800mA
Red. Power