Herunterladen Inhalt Inhalt Diese Seite drucken

Important Notes Concerning The Warranty; Troubleshooting - Sartorius Stedim Biotech Sterisart 16419 Bedienungsanleitung

Universal-pumpe
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

11.
Important Notes
Concerning the Warranty
The correct functioning and safe
use of the Sterisart
is only guaranteed when it is oper-
ated according to the information
given in these instructions.
The equipment manufacturer is
responsible only for effects on
safety, dependability and perform-
ance of the instrument if assembly,
extensions, new settings, changes
or repairs are carried out by persons
authorized by him to do so, if the
electrical installation in the room is
in conformance with IEC require-
ments and if the equipment is used
in accordance with these operating
instructions.
Any changes made to the Sterisart
Universal pump will invalidate the
manufacturer's warranty unless
they are previously agreed to by
authorized Sartorius Service staff,
or carried out by them.
Downloaded from
www.Manualslib.com
12.
®
Universal pump
®
manuals search engine

Troubleshooting

This section lists a few problems that could arise in connection with the Sterisart
pump. Several solutions are given for each problem. The first solution given is
usually the most likely one. If this does not solve the problem, go down the list of
suggestions until the problem has been solved.
The pump must be switched off before electrical connections are unplugged
or plugged in!
Should it not be possible to locate and solve the problem in this way, contact the
appropriate service center (see the back cover of this manual).
Problem
Solution
No function;
The pump is not switched on, or is not correctly
no display
connected to the electric supply.
Plug the power cable into the electric outlet correctly
and to the Sterisart
on-off switch.
Check the electric supply; switch on multiple outlet
sockets; check the wiring.
If these possibilities are not feasible, the primary fuse
in the main line filter may be defective.
Changing this, with the power cable unplugged, must
only be performed by authorized personnel!
The pump rotor
The locking lever is open or the foot switch is not
does not rotate.
properly connected.
The bow has been removed from the pump.
Check the connection of the foot switch to the pump.
®
Universal pump. Switch on the
®
9

Werbung

Kapitel

Inhaltsverzeichnis
loading

Inhaltsverzeichnis