Maico AE 10/1 Montage- Und Betriebsanleitung Seite 42

AE 10/1, AE 15/1
cable. Cut a minimum of 5 mm off the cap
(power cable can bend better and electronics
cover can be positioned correctly).
Fit cable grommet correctly, seal on site

if required.
8. Insert the cable grommet in the housing.
9. Feed power cable into the connection
area such that the cable grommet fits
around the cable sheathing completely
and does not penetrate too far into
terminal compartment.
10. Make the electrical connection
Chapter
11. Fit cover unit (design cover [6] with
housing cover [5]) and engage it in safety
DE
9.
UK
VENTILATOREN

FR