3M H-700 Handbuch Seite 86

An
3M™ Industrial Safety Helmet H-700/H-701
INTENDED USE
This product meets the requirements of
EN397:2012, Industrial Safety Helmets. This product
is designed to protect the wearer against objects
likely to strike the head. This product also meets the
optional requirements for very low temperatures
(-30°C). Versions are available that also fulfil the
requirements for electrical insulation and molten
metal splash. This product also meets the
the requirement for very low temperatures (-50°C).
Product marked with the double triangle symbol
marking fulfils the requirements for Electrically
Insulating Helmets in accordance with EN50365:2002.
See all instructions for use and save for continuing
reference.
^ Particular attention should be given to
warning statements where indicated.
^ WARNING
- Suitable for the application;
- Fitted correctly;
- Worn during all periods of exposure;
- Replaced when necessary.
maintenance are essential in order for the
product to help protect the wearer from impact
hazards.
ailure to ollow all instructions on the use o
these personal protection products and/or
ailure to properl wear the complete
product during all periods o e posure ma
adversel a ect the wearer s health lead to
severe or li e threatening illness or
permanent disabilit .
regulations, refer to all information supplied or
contact an occupational hygienist, safety
professional or 3M representative on the Tech
be adjusted to the size of the users head.
blow by partial destruction or damage to the
shell and the harness, and even though such
damage may not be readily apparent, any
helmet subjected to severe impact should be
replaced.
danger of modifying or removing any of the
original component parts of the helmet, other
than as recommended by the helmet
manufacturer. Helmets should not be adapted
for the purpose of fitting attachments in any way
not recommended by the helmet manufacturer.
self-adhesive labels, except in accordance with
instructions from the helmet manufacturer.
substances containing solvents and/or alcohols
can reduce the durability of the helmet and
should therefore be avoided.
industrial areas only and the helmet should not
be used in any other application such as horse
riding or bike riding.
maintained and correctly adjusted to the users
head.
further advice.
PREPARATI N
Inspection
Ensure that the head harness is always attached to
the helmet at the appropriate points and securely
fitted to the head before it is worn. If required,
replace the complete head harness assembly only.
Before each use the helmet should be inspected for
cracks, cuts or other damage and should be rejected
and disposed of if these are discovered.
has not turned completely white, as this indicates
itting
(See figure 1). It is important that the headbands are
properly tensioned in their attachments.
This product is also approved with the interior rotated
elmet ad ustment See igure
correctly. Tighten the nape strap so that the helmet
sits securely. For the standard suspension, press the
studs into the holes.
The height of the head harness can be set at a
choice of 3 vertical height settings for optimum
comfort (See figure 3).
85
R USE