Cleaning Programmes And Operating Modes; Cleaning Programmes - Bosch Roxxter BCR1 Serie Gebrauchsanleitung

en

Cleaning programmes and operating modes

Cleaning programmes

10
The robot vacuum has various cleaning programmes for
cleaning specific rooms or areas.
You can select and control the cleaning programmes
using the controls on the robot vacuum or via the Home
Connect app.
ALL cleaning programme
10
Fig.
With the ALL cleaning programme, the robot vacuum
cleans all accessible rooms one after the other.
When you start the ALL cleaning programme, the ro-
bot vacuum will survey its immediate surroundings and
create a temporary map. It will then start systematically
cleaning the area it has surveyed.
Large rooms will be divided into areas of around 20 m 2
each. The robot vacuum will divide rooms into smaller
areas automatically.
It will then move over and clean the individual areas in
lines parallel to the long side of the area boundary.
It will detect any areas it has missed and clean them
separately at the end.
The Silent, Eco and Power operating modes can be set
for this cleaning programme. You can find detailed in-
formation about the operating modes in the „Operating
17
modes" section. Fig.
Once all accessible rooms have been cleaned, the ro-
bot vacuum will go back to the place where it started
cleaning.
If the battery level is too low, the robot vacuum will re-
turn to its original position and the programme will be
paused. If cleaning started from the charging station,
the robot will recharge itself (once only) and then re-
sume cleaning. Otherwise, it will go into energy-saving
mode.
77