Herunterladen Inhalt Inhalt Diese Seite drucken

Installation - Oase LunAqua Classic LED Set 1 Gebrauchsanleitung

Vorschau ausblenden Andere Handbücher für LunAqua Classic LED Set 1:
Inhaltsverzeichnis

Werbung

Correct electrical installation
− Electrical installations must meet the national regulations and may only be carried out by a qualified electrician.
− A person is regarded as a qualified electrician, if, due to his/her vocational education, knowledge and experience, he
or she is capable of and authorised to judge and carry out the work commissioned to him/her. This also includes the
recognition of possible hazards and the adherence to the pertinent regional and national standards, rules and regu-
lations.
− For your own safety, please consult a qualified electrician.
− The unit may only be connected when the electrical data of the unit and the power supply coincide. The unit data is
to be found on the unit type plate or on the packaging, or in this manual.
− Ensure that the unit is fused for a rated fault current of max. 30 mA by means of a fault current protection device.
− Extension cables and power distributors (e. g. outlet strips) must be suitable for outdoor use.
− Install the transformer at a minimum safety distance of 2 m from the water.
− Ensure that the power connection cable cross section is not smaller than that of the rubber sheath with the identifi-
cation H05RN-F. Extension cables must meet DIN VDE 0620.
− Protect the plug connections from moisture.
− Only plug the unit into a correctly fitted socket.
Safe operation
− Never operate the unit if either the electrical cables or the housing are defective!
− Do not carry or pull the unit by its electrical cable.
− Route cords/hoses/lines in a way that they are protected against damage, and ensure that they do not present a
tripping obstacle.
− Only open the unit housing or its attendant components, when this is explicitly required in the operating instructions.
− Only execute work on the unit that is described in this manual. If problems cannot be overcome, please contact an
authorised customer service point or, when in doubt, the manufacturer.
− Only use original spare parts and accessories for the unit.
− Never carry out technical modifications to the unit.
− The power connection cables cannot be replaced. When the cable is damaged, the unit or the component needs to
be disposed of.
− Only operate the unit with the supplied transformer.
− Keep the socket and power plug dry.
− The power pack and the plug connectors of the power cables supplied are not water-tight, but only rain and splash-
proof. Do not route or fit in the water.

Installation

The unit is supplied fully assembled as a complete set with a transformer and one or three LED spotlights, including
bulbs.
Installation (B-C)
− The foot can either be stood on the ground or bolted to a firm base or load bearing wall (B).
− Position the unit in such a way that it does not present a hazard to anybody.
− Adjust the tilt of the light (C, 1) and fix it at this angle with the screw connection (C, 4).
− Connect the plug of the spotlight connection cable to the socket on the transformer and tighten the union nut (C, 5)
hand-tight.
- GB -
7

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Lunaqua classic led set 3

Inhaltsverzeichnis